Who does the work
Manny has spent his career on roofs in this part of Massachusetts, and the way Ecos Roofing runs a job reflects that: measure first, write down what was found, then talk about what to do. The crew is built around residential and commercial roofing, roof restoration and full replacement, storm and leak repair, skylights, siding, and gutters, soffit and fascia work, rather than trying to be everything to everyone.
Every roof gets the same starting point regardless of size: a walk of the attic, a count of the shingle layers, a check of the flashing at every penetration, and a written note of what was found before any recommendation gets made.
Residential and commercial, side by side
Residential work covers single-family capes and colonials, the triple-deckers common across the city, and the beach-adjacent cottages closer to the water. Commercial work covers the low-slope roofs on the mill-era buildings and smaller retail properties along the waterfront corridor, where drains, scuppers and edge metal fail first and get checked on their own schedule rather than waiting for a leak.
The housing this crew knows
Fall River is a mill city built up around triple-deckers, older colonials and capes, and commercial buildings that once served the textile industry along the waterfront. A large share of those roofs carry more than one layer of old shingle, plank decking instead of plywood, and flashing details that were done to whatever standard was common decades ago rather than a current one.
That housing stock sets the priorities on every job: a proper deck allowance built into every replacement estimate, flashing that gets replaced rather than patched, and ventilation that gets fixed rather than ignored, because skipping any of those three is how a roof in this city fails early.
Working around the bay
Mount Hope Bay shapes almost every material decision made here. Salt air corrodes ordinary galvanized fasteners faster than it does anywhere inland, so stainless or hot-dipped galvanized hardware is standard on anything close to the water, whether that is a house in Fall River itself, along the Somerset riverfront near the Braga Bridge, or out toward the open water near Westport and Horseneck.
Wind is the other constant. A roof here needs to handle a nor'easter through the winter months and the occasional tropical system in late summer, and both push wind and rain sideways in ways a standard inland nailing pattern does not account for. Six nails per shingle, high-wind rated ridge cap, and adhesive-sealed starter strip are the baseline on every job in the service area, not an upgrade.
How a job runs
A first visit is a walk-through, inside and on the roof, followed by a written scope that lists exactly what was found and what is recommended. Photos are taken before, during and after the work so there is a record of the deck and flashing condition that gets covered up by the finished roof.
Landscaping is protected before a tear-off starts, the dumpster and material staging are placed to minimize damage to the yard and driveway, and the site is magnet-swept for nails before the crew calls the job done. Homeowners are encouraged to walk the finished roof from the ground with the crew lead before anyone packs up.